Rectangular WYE branch

The wye tees are fitted with sheet angles, and the entire fitting is braced by cross-wise ribbing. This fitting allows building the duct work with two take-offs set at any angle.
#Available Materials: Galvanized, Aluminium, Stainless Steel.
#Thickness: 26 -18 gauge for Galvanized, .032 - .050 gauge for Aluminium, 24-20 gauge for Stainless Steel
#Length: 100mm-5000mm*
#Finishing type: TDF, S&D, Raw
#Inclusive: Bolt & Nuts, TDF Corners, Gasket, C Cleat
# The width may vary between the two take-off ports